How to install the interior door correctly. A Beginner's Guide

When installing doors, the most difficult thing is assembling the box and hanging the hinges. And here every stage of work is important, correct measurements, carefully selected door and the main thing to pay attention to how to insert the door correctly, how to fix it. To work it is necessary to be taken responsibly and attentively, with energy and mood. Then all by all means will turn out. And to help you below it will be described in detail and step by step how to properly install the interior door.

Step 1. The box is assembled on the door with a minimum gap of 2-3 mm on each side. You can fasten, both with the help of nails, and long self-tapping screws. Just make sure that the tree does not crack. When adjusting the edges of the box, the joints should be cut with a hacksaw and the surplus removed with a chisel

It is more difficult to collect cheap, so-called, "paper" doors. They are more gentle. The gap between the box and the doors is slightly larger, about 2-5 mm above and below, and 2-4 mm at the edges. The corners of the box should not be attempted with nails or self-tapping screws. Since the pressed paper will still burst. Such boxes are better to collect with the help of corners (or those used for assembling the frame for drywall, or furniture corners).

You can not try to assemble a box with right angles at 90 degrees. At the moment even very expensive doors have a small curvature.

Step 2. The next stage, explaining how to properly install the door, will be the fixing of canopies (loops). The hinges are left and right. They are put on the side in which the door should open. This moment is very important, and not to be mistaken, you can double-check everything.

First, the hinges are attached to the canvas of the box. To do this, they should be enclosed and penciled around the contours. Then, along this contour, a depression is made a couple of millimeters deep, so that the loop "drowns" in the tree, but does not sink. In the same way, you install the hinges on the door. Then everything is fixed with screws that come complete with loops.

Step 3. Now proceed directly to the very answer to the question that tormented all who are in a state of repair: how to install the interior door correctly . Installation is carried out after assembly and fastening of loops. The door is exposed in the opening on the level. It is desirable to level the "throw" on all sides of the box, for fidelity.

That the exposed door anywhere "did not run away", on edges and in the middle it is desirable to drive wooden wedges. But they should not be too thick, otherwise they will buckle the door frame and the door will not close. But too small wedges do not fit, they should not fall out.

So, the wedges are clogged, the door is set in place. Now it should be fixed with the help of anchors. First, drill holes or perforators make holes through the box into the wall. Then they screw in the anchor, he fastens the box to the wall. They twist pieces of 2-3 on each side. Fixation completes the mounting foam.

Before you foam, you need to properly "unlock" the door frame. For example, put a loose cardboard on all sides and close the doors tightly. Now you can fill the voids with foam. But different foams have different degrees of swelling, so it is better to fill the openings halfway.

It is important not only to choose how to properly install the interior door, but also to give it a deadline for final fixing. It will take 6-12 hours, during which it is not necessary to open the doors. This is how you need to let the foam come to grips and then it will be possible to cut off the surplus carefully with a clerical knife.

Now it is clear how to properly install the interior door. True work on this is not finished, because the process of cashing it out (that is, it is necessary to put the platbands) ahead, perhaps, varnishing (depending on the type of door). But this is a completely different story.