How to install a water heater with your own hands

It's no secret that most of the city's communications have long since lacked hot water. This is due to various reasons that neither the public utilities themselves nor the city authorities can explain. However, even in those houses where hot water is present, the installation of the water heater by oneself is made.

This is due to the fact that in most cases the price for heated water provided by urban companies is much higher than the cost of electricity spent on heating exactly the same amount. At the same time, a person does not depend on various services and can use this benefit of civilization at any time. This state of affairs constantly raises the question of how to make the right choice of the water heater.

To date, there is a large number of devices for heating water with the help of electrical energy. However, almost all of them have the same principle of operation, based on the use of heaters that work as an active resistance. Excellent only are the functionality, power consumption and the volume of the working tank. And it is capacity and is the main criterion in choosing.

Another important point when buying such a device is the installation of a water heater. The price for such a service is usually not included in the purchase price, which requires the buyer additional costs, not only for the payment of the installation itself, but also for the acquisition of additional parts. Therefore, in most cases, the installation of the water heater by yourself. However, it requires certain skills in the field of plumbing.

First, the user needs to determine the location of the device. It must have access to water supply pipes and a power supply system. Then, with the help of special fasteners or impact dowels, the water heater is installed by hands on the height specified in its instruction. After that, the water supply system is connected to it. And the cold water pipe is attached to the entrance, painted in blue, and the pipe hot - to the red exit.

Further, the heater is connected to the electrical network. To do this, simply insert the plug into the network. However, in old houses the wiring can not withstand the load, so it is replaced by a good wire with a large cross-section, which is connected directly to the input cable.

Considering such works, which involve access to electricity and to the water supply system, the installation of the water heater by one's own hands must be carried out in strict accordance with safety requirements and with certain experience. Do not do this without proper preparation and a certain tool, as this can lead not only to the exit from the standing water supply system or power supply, but also to injury. Therefore, in this situation it is better to use the work of professionals who have not only a lot of experience, but also the proper equipment.