HomelinessRepairs

Warmstad - warm floor, which can be installed independently

Count only today on central heating can not. Therefore, property owners are increasingly resorting to the installation of additional systems that provide comfort and comfort inside the premises of the house. You, too, can follow the experience of the majority.

Warmstad - a warm floor, which works by electricity and is a high-quality heating system. It is affordable, suitable for use in any location. These warm floors are certified, they were developed according to the latest technologies, safe and reliable.

Reviews about the characteristics

Warmstad - a warm floor with many advantages, among them one can distinguish that it is a product manufactured by a domestic manufacturer, which is very popular with consumers. It can be operated taking into account climatic features and other factors. Buyers say that you can be sure that this system is reliable, because it is able to work for 15 years or more, which is due to the unique polymeric shell of the cable. The consumer likes that the manufacturer repeatedly tested the system, and then began to supply it to the European market.

Features of installation of a warm floor of mark "Varmstad"

Warmstad is a warm floor that can be installed in one of a variety of technologies. For this it is necessary to take care of the availability of appropriate materials and tools. Among them, it should be noted:

  • RCD protection system;
  • Connecting wires;
  • System of warm floors;
  • Fastening;
  • Copper cable for grounding.

Surface preparation before installation

Warm floor electric Warmstad should be installed on a pre-prepared surface. The screed layer is dismantled to the base, if such a need is present. The surface must be cleaned, and then lay a layer of waterproofing, bringing it to the surface of the wall, on average, 7 cm. At the perimeter of the room, a damper belt is installed along the wall , which compensates for the thermal expansion of materials upon heating.

In order that thermal energy does not go to the neighbors down, the base is isolated. Depending on how the premises are located, and also what purpose they have, you can conduct insulation. Thus, Warmstad wsm can be supplemented with expanded polystyrene sheets, which have a thickness in the range of 20 to 50 mm. As an alternative solution, another heater of suitable thickness is used. These recommendations are true for apartments with warm rooms, when the living rooms are lower. If the installation of a warm floor is carried out on an unheated loggia or veranda, it is necessary to form a solid layer of insulation, its thickness can reach 100 mm. In this case, the warm floor of Warmstad, whose reviews are only the most positive, is supplemented with mineral wool or expanded polystyrene.

Mounting

Before you start laying the electric underfloor heating, you should check the wires. You can fasten the system to the reinforcing mesh with the help of screeds, but do not tighten too much. You can use fasteners. If the floor is installed in the bathroom or bath, the reinforcing mesh is grounded, and the ground is fed to the regulator. To do this, you can use a copper wire. Warmstad - a warm floor, which simply spreads over the surface of the insulation. The technology provides for the use of special construction tape, sometimes fixing is done for special ears.

In addition to the ways of installing the electric floor Warmstad

Before you make an acquisition, you can decide on which technology you will install the system. You can lay it in a layer of screed or on top of it under a tile. Some masters use the technique in which the system is laid under the floor covering. The first option is great for living rooms, loggias, kitchens and bathrooms. In this case under the system should be laid not only the layer of insulation, but also waterproofing. From above you can form a small layer of screed.

Conclusion

If the insulated space is located below, it is recommended to lay the electric warm floor before laying the tiles. This additional insulation is not required. Tile glue and tiles will perfectly protect the heating elements. However, in the instructions you should specify whether there is the possibility of such a styling.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.birmiss.com. Theme powered by WordPress.