It is difficult to imagine life in an apartment without electricity. Unfortunately, sometimes there are situations when the wiring in the apartment needs urgent replacement. The reasons are different - out of order, not powerful enough (appliances "cut down" the counter), you need to transfer the sockets and switches. Yes, you never know! How to carry out all the procedures without compromising your wallet and security?
Replacement of wiring in the apartment
If the room is already residential, and not just built, then first you need to dismantle the old wiring. How? Ideally - to call the electrician. If you have sufficient knowledge in this field, then you can do it yourself. First, the electricity meter is turned off . If all the rooms in the apartment are summed up to the meter separately, then they should not be disabled. This is, of course, necessary for security. Then the old wires are disconnected from the meter and from the devices (sockets, switches). All this is done in high-density rubber gloves. These are the minimum safety requirements.
Wiring in the apartment is a dangerous plexus of wires. Especially if her careless master spent many years ago. After everything is disabled, you can remove all the wires. This applies to the wiring that was launched at the top. That is, outside the walls. With the dismantling of the wiring, which is inside the walls, it is more difficult. You need at least some to know where it goes. To look it is possible on razvetkobke. If previously the wires were not put into a special tube (corrugated), then it will be necessary to break the walls and ceiling depending on where the wires are sent. If they were in the tube, then it is enough to pull them out. It will require effort.
New posting
Before you post in the apartment, you need to make the preparatory work. First, you need to decide on where all the sockets and switches in the rooms will be located. Do not forget about the chandeliers. Secondly, you need to choose the wires. Wiring in the apartment, where a large number of electrical appliances, requires wires with a special section and thickness. Which ones? It all depends on your needs. One of the best and lasting wires is copper with a cross section of 0.5 mm. Third, you need to determine how the wiring for the apartment will go. Will it be external or internal. Each of them has its advantages and disadvantages. Outdoor is good because it is always in sight, and it can easily be replaced. The disadvantage is that it does not always look beautiful and fits into the design. Internal with proper installation is safe and does not strike the eye. The disadvantage is that if there is a need for replacement, there are difficulties. The interior is better to be allowed into a special pipe, which has the property of extinguishing all fires in an emergency situation. On the counter there must necessarily be toggle switches, which will work during the overload. All procedures for connecting new wires to the meter should be done by a master electrician. The wiring in the apartment can not be completely replaced by yourself unless you are an electrician.