How to make a visor over the porch

In order to give the building a complete, and sometimes original look, install a visor over the porch of the front door. However, this exterior detail does not only aesthetic function, but also serves as a shelter from rain, snow or sunlight. In addition, the visor over the door protects against the fall of icicles or plaster.

Canopies and canopies, with the right approach, allocate an office or a house among many others. With regard to gambling facilities and service organizations, this is especially important, since neat and well-maintained buildings with a properly decorated entrance attract visitors' attention.

Canopies above the entrance of the polycarbonate are resistant to temperature differences (-60 - +110 degrees) and sufficient impact resistance. There are other materials for manufacturing entrance canopies - wood, metal and ordinary tiles. But polycarbonate is the most suitable material, because it has such properties as fire resistance and the ability to retain ultraviolet radiation.

The assortment of polycarbonate colors is diverse, which makes it possible to organize a single and harmonious composition of the facade. In addition, the canopy can be decorated with forged or welded products - decorative details on the visor, handrails, fences or lanterns.

The visor above the porch, made of polycarbonate, will last much longer than with other materials. This material is not corroded, that is, it does not rust, crack or deform. In addition, polycarbonate sheet can be given almost any shape due to its flexibility.

After the material for the visor and frame is chosen, and the necessary amount is calculated, the question naturally arises: "How to make a canopy or visor above the entrance"? Still, not everyone has the opportunity to call specialists for this.

The manufacture of such a product with their own hands is not particularly difficult. To start the construction of a canopy it is necessary with the erection of a skeleton made of galvanized metal profile, which provides stability to loads and strength. Support posts should be located at a distance of one to one and a half meters from the facade.

Also, the supports can be made of wooden beams. However, you need to make sure that they do not touch the ground directly, otherwise the tree will rot.

If the foundation is made of concrete, then it will be enough to screw the posts into the anchor with the help of screws. Then they set the crossbeams and arrange the skeleton for the visor.

After the racks and frame are installed, you can mount the visor itself above the porch. Let us consider this process using the example of polycarbonate.

The sheet is attached to the frame using the same screws, and the interval should be small, since the connection must withstand any wind. To process this material, you can use the same tools that you need to work with metal or wood.

The task of installing a visor made of polycarbonate greatly facilitates the fact that it weighs relatively little. In the event that several polycarbonate sheets are required for the canopy, the joints must be closed, for example, using a decorative strip of aluminum. Then, in the middle of the canopy, an additional longitudinal support is installed. However, this moment is relevant only in the case of installing a canopy with a large surface area, and for a visor above the porch there will be enough one sheet, or even less.

The visor above the porch can be arranged both in the form of an arch and in the form of a sloping ramp, or you can give it a triangular shape, as on a typical roof. Polycarbonate poles do not need special care - all dirt can easily be removed with a wet cloth, if necessary, you can use non-abrasive detergents without ammonia.