How to make a knife sharpener with your own hands?

Absolutely each of us several times a year there is a need for sharpening knives. Steel at the ends is gradually worn off, and when the moment comes when we need to do our best to cut vegetables or bread, we think about how to sharpen this tool. Of course, you can use the ancient grandfather's method and process the metal with a file. But you can go the other way, using a special sharpening for these purposes. And if you have a desire to do something, you can make it yourself. If so, this article is for you. So, how is the Lansky sharpener made? Can you create something like that with your own hands?

Preparing the board

First we need to take a board about 35-40 centimeters long. In it, with the help of a drill, it is necessary to make a hole. Drill it you need only in the center, and not from the edge or anywhere else. The width of the hole should be 10-11 millimeters. Now this board must be clamped in a vice and polished all its irregularities with a file. After that, additionally treat its surface with coarse-grained emery paper.

Operations with a bolt

It is necessary to cut off from the slats 4 segments (approximately 80 millimeters), in each of them to make one hole. However, it is necessary to drill here not in the center, but along the edge (slightly closer to one of the sides). How else is the knife sharpener made with your own hands? In the following steps, take a bolt, pass it through one board with an opening and place it in the slot. In this case, it is also necessary to install a bolt on the second section of the rail and screw it with an additional nut. With the rest of the boards do the same. As a result, you should get something like a vice. When these "vices" are ready, we can assume that we have already coped with one half of the device.

How to make a knife sharpener with your own hands ? Finalize the second part of the mechanism

Now it remains to finish the rest of our grindstone. To do this, we need another 40-cm board, rake and a piece of leather. The latter should be tightened very tightly on the surface of the slats, and the top should be clogged with nails (the texture side of the skin should be concave inwards). The finished instrument is attached to the board. All, at this stage, we can assume that the knife sharpener with their own hands has been successfully done. We only need to cut the edges of the boards in such a way that both halves of the device stand vertically at a certain angle. The tilt level need not be 45 degrees. Choose the slope of the board so that it is convenient for you to use it. Now nail the device to the base (leave a small gap between the surface of the base and the sharpener), then place something like a lid in the left slot. To do this, you can use the remaining pieces of trimmed boards. Everything, at this stage, the knife sharpener with its own hands has been successfully done. Now you can safely proceed to its operation. Such a sharpener for ceramic knives will be the best cutting device and your reliable assistant in the household!