Warming the frame house: tips

Frame houses are classified as inexpensive, practical buildings that require work to preserve heat and prevent the penetration of moisture. Warming of the walls of the frame house is made using foam or mineral wool, which is laid between the skin. These materials will provide comfort, energy saving, noise insulation and durability. When working internally, a special film is installed on the walls, which eliminates the vapor barrier.

The insulation of the frame house is made in several stages with observance of certain technology. It is necessary to remember the protection of the heater from the effects of moisture, which can accumulate inside the frame, condensing and slowly drying out, which favors the formation of microbes and mold. Good material has materials based on mineral wool, they absorb water well.

A high index of permeability is possessed by glass wool. This material is easy to lay, does not decompose, does not absorb moisture. Making the insulation of the frame house, the glass wool should be covered with a windproof film, this will allow the heat to stay inside the room for a long time.

A good thermal insulation material is foam. Today, various types of these products are manufactured, which have increased fire-resistant properties. An excellent quick-drying material, allowing air to penetrate, appears penoizol. It is recommended to use it from the outside, covering it with a vapor-permeable material.

Recently, stone wool has spread widely . It is a kind of mineral wool. Because of its high vapor permeability, it always remains dry. Stone fiber includes in its composition components that are capable of increasing moisture repellent properties. Warming the frame house with cotton wool will provide fire protection at home. This product is easy to install, it is flexible and flexible. In the southern regions, claydite materials and slag can be used for insulation.

Carrying out the insulation of the frame house foam, you need to pay attention to the fact that between the logs and in the corners there were no crevices. Through them, cold air can enter. Therefore, you need to carefully examine from inside all the walls.

First of all, it is necessary to determine the places and areas where it blows or where it gets wet. The cracks and holes that have been found need to be sealed with a mounting foam or a sticker. If necessary, remove the inner lining. It is more difficult to heat the ceiling, since it is possible to leak out to the outside of warm air. To eliminate this problem, use sawdust with additives, eco or mineral wool. If the material is loose, then it must be crushed.

Warming of the frame house can be done from two sides: inside and outside. In this case, the layer of heat-insulating material must be not less than 15 centimeters. It is not recommended to cover the surface with a ruberoid, it should be placed not on top, but under a heater.

Polyfoam for insulation take a thickness of at least 5 cm. The installation is performed on the facade, after cleaning the working surface of the contamination, removing the protruding and uneven areas. All cracks and chips should be treated with a primer with a deep penetration. Vertical sheds of polystyrene are installed using cords, observing a distance of half a meter.

When mounting the rows in the level, a profile strip is exposed. Polyfoam to the wall is attached with glue, which is applied at five points of the sheet and along the edges with a uniform strip. For better resistance to wind, the foam can be fastened with dowels or self-tapping screws with wide disk caps. On the sheet, five pieces are enough, after which they are primed with a glue solution.