HomelinessRepairs

Repair Without Problems Or What is a Liquid Film

Everyone who has ever faced a repair, be it a builder or a customer, knows first hand what is in store for him at the final stage of the delivery of the property. This is scratched windows, doors, plumbing, floors, etc. Moreover, all this is accompanied by contamination with cement, scotch, a primer and other substances, which are difficult to clean later on. In this article I will tell you how this can be easily avoided.

What is a liquid film?

Despite the fact that the material appeared relatively recently (about 2 years), in Europe it is already practiced quite widely, due to the convenience of its application.

Liquid film "Quart" is a polymer that solidifies (polymerizes) when interacting with air. Not toxic. The material is intended for temporary protection of various surfaces. The condition for a liquid film is one - the surface must not be absorbent. If to speak as a whole, put this film as a paint, and then shoot as an ordinary film (a single piece). Everything is very simple.

One of the most important advantages of this material is that it has an absorbent capacity. In other words, if you have applied the film to the surface (even if it was dusty and dirty), when you remove this film, the surface remains perfectly clean. Liquid film simply absorbs everything that is under it.

Where and how is it applied?

Liquid film "KVARTA" is used in such critical areas as: windows, doors, plumbing, glass, metal, plastic, granite, marble, advertising in shop windows, cars and other non-porous surfaces.

To apply a film it is possible in several ways: a spray, a platen or a brush. Here the choice is yours, it all depends on the convenience of one way or another. When using a liquid film, it is necessary to take into account the temperature regime. Apply the film at a plus temperature, preferably from +10 degrees Celsius, the same applies to removing the film. If you need to remove the film at a negative temperature, then you will shoot it just like ice, it will simply be broken off pieces.

When using a liquid film, we achieve savings on several items:

1. Time to defend. All other methods like construction film, scotch tape, plywood, dsp, etc. Rather labor-intensive, although at first glance it is cheaper.

2. The quality of protection is 99%, once covered and forgotten.

3. There is no need to clean and wash the surfaces after the work done. It is easier to remove film than to wash scotch and other substances.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.birmiss.com. Theme powered by WordPress.