HomelinessDo it yourself

Installation of the toilet bowl installation with your own hands

Installation of the toilet installation implies its installation by a load-bearing metal structure, made in the form of a frame. Work on the installation of this sanitary equipment can be carried out in private houses, as well as in apartments, cottages, cottages and even baths. And despite the fact that the design of this device is very complicated, there are practically no problems with its installation. Moreover, the installation of this equipment can be done without the help of specialists and the use of special tools. Further in our article on how to install the installation of the toilet with your own hands.

What is the essence of the work?

How does it turn out that the design of the suspended toilet bowl is complicated, and the installation can be made, limited to a minimum set of spanners and drills? The fact is that the manufacturer took care of this stage in advance and provided for all possible difficulties. In fact, the installation of the toilet installation is reduced to the connection of the device to the water supply system, the sewage system and the support of the support beam.

Getting Started

It is also worth noting that despite the variations of this equipment, the principle of their installation remains the same, therefore this instruction, given below, can be applied absolutely to any hanging toilet bowl.

The first step is to install the frame in a niche. If the latter is not, then the installation of the structure is made to the wall: all calculations are adjusted in height in such a way that the distance from the toilet to the floor is not more than 40 centimeters. This value corresponds to the normative dimensions of an adult.

After that, a marking of the center of the fixing holes in the brackets is made in the wall or on the floor. According to the scheme, the work is carried out in the following way: dowels or anchor screws are driven on concrete or brick floors, and self-tapping screws on wood.

Further installation of the toilet installation is accompanied by the installation of the module (it is important to avoid the occurrence of gaps) and the connection of the device to the water supply and sewerage systems. After that, a mounting cover is attached to the threaded studs and push button module of the drain and the wall is walled together with the module itself. However, at this stage, the installation of the toilet installation has not yet been completed. After installing the housing, it is necessary to fit a special gasket on the threaded studs and tighten all the nuts of the device. In this case, the toilet bowl should be in tight contact with the wall surface and the floor. The drainage mechanism is connected to the tank through a small plastic tube and inserted into a rectangular hole, which must be formed when trimming the drain casing. Everything, at this stage the installation of the suspended toilet bowl with the installation has been successfully completed.

Tip

Finally, we note that to further adjust the water supply and discharge speed, you must first pull out the button module, after which all hidden mechanisms will be available, including the water supply and the float system.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.birmiss.com. Theme powered by WordPress.