Automobiles, Cars
How to repair a bumper with your own hands
Most motorists, which is logical, protects their iron horse from all kinds of damage. One is unpleasant to ride a broken car with scratches, others it is important to sell in the future, and it is profitable, there are also those who simply feel sorry for their car, trying not to deliver "injuries" to it. Most often, if the accident did happen, it primarily concerns the bumper. As you know, almost all cars today are equipped with plastic bumpers, so there is such a need as a local car repair.
Of course, there are cases when the damage does not go beyond the bumper, then there is another question about how to repair the plastic bumper. In fact, there are not too many options. As a rule, it is done in car-care centers, but almost every car enthusiast can do it.
To do this, you need a fine-grained mesh, a soldering iron, preferably 100-Watt, a bit of a solvent and the like of a table, on which you can put a bumper. It would not be unnecessary to build a hair dryer. To begin with, the bumper needs to be removed from the car and cleaned of dust and dirt, the place of breakage should be thoroughly washed, then it should be dried and degreased, as a degreaser you can use a solvent 646 or 647, which you can actually find in any hardware store. Auto services also use 650, because it is used to dilute paints and is constantly available.
"How to repair a bumper with your own hands" - there are a lot of articles on this subject on the Internet, but, as a rule, it is rather difficult to find step-by-step instructions. But we will not be distracted from the topic. We stopped on the need to dry everything up. After that, you should use a hairdryer, but if it's not there, it's okay, it's needed in order to more accurately install the fragments together. It is known that when the objects are heated, the objects expand, so that in this way one can avoid cracks when aligned.
This is a rather important stage, since the service life will depend on how to repair it. The bumper is under rather aggressive conditions during operation, it is hit by road pavement, if it is a country road, a grass that can be quite stiff, removes the paintwork even before the primer, to the plastic itself. Therefore, the state of the bumper must be constantly monitored, because the damage in the form of tearing off the fasteners can be prevented by first reinforcing them.
Of course, if all this is not done, and do not take care of the front part on the descents, on the upsurge, then there is a problem and the question of how to repair the bumper. But we will continue our "instruction". Now we must briefly leave the bumper and cut the mesh with rectangles of 1x2cm, it should preferably be with a stainless coating, as rust can protrude into the remaining slit with water.
After that, the soldering iron is heated, a net is applied, and then pressed first so that the molten plastic protrudes through the cells. It is not necessary to smooth out the resulting ribbing, it's not even worth it, because strength will suffer from this. It is worthwhile to clarify that all operations are performed from the inside. Of course, it would be better to do the same with the outside, but then there is a need for painting. The article briefly describes how to repair a bumper.
Similar articles
Trending Now