HomelinessDo it yourself

How to connect a running water heater to the system?

Have you already decided on the choice of the device for heating the water? Here already and the purchase was made, there is very little left: connect the device to the water supply system. It is not always easy to do this. Every man who is used to doing homework himself knows how to connect a running water heater. But in some situations it is desirable to call a specialist. For example, if there are plastic pipes in the house, then the installation should be carried out using a special method of cold welding - soldering. Let's review the instructions on how to install a running water heater.

Water connection

Before proceeding with the installation of the water heater, it is necessary to make a connection point to the power supply. There are two types of water heaters: electric and gas.

  1. How to connect a running water heater to electricity? Everything is simple enough. First you need to check what current can withstand the domestic electricity network. If you understand this, then there will be no problems: you can safely put the machine (electric power switch) and connect the device. In the event that the power network can not withstand the voltage from the water heater, it is necessary to consult an electrician. It may be necessary to change the whole electricity supply system in the house.
  2. How to connect a running water heater running on gas? To begin with, even this device needs electricity. The gas column has a panel of programs that operate from the mains. But in the process of heating the liquid only gas takes part. This type of fuel in the combustion process emits enough heat to heat the water.

Connection Features

How to connect a running water heater? Each model of this device has two tubes: for cold water (input) and for hot (output from the heater). Before connecting the device, determine for what needs you need it. If the hot water you need only in the bathroom, the output from the device can be directly connected to the tap near it. In this way, residents of flats are most often used, since they need a running water heater only for the period of switching off the centralized hot water supply. To do this, you can connect the device directly to the mixer in the shower. Residents of private homes in this regard are unlucky: they do not have the opportunity to receive warm water from the central system. In the case where it is necessary to ensure the flow of water to the kitchen, into the sink, shower stall, water heater is installed on the entire system of water supply to the house.

Advice

  1. The first step before attaching the flow-through water heater is installing the power supply. This approach is not only rational, but also safe, since there are often cases when the owner overestimated the electrical system's capabilities in the house and as a result received the burned wiring. Moreover, the connection to the power supply must be correct so that the plugs on the counter do not knock out from the high power of the device.
  2. Before buying a heater, consult a specialist to not regret the low power of the device and the poor heating of the liquid.
  3. If you are going on vacation or on a summer residence, do not forget to turn off the automatic device on the power panel. This will protect your apartment from possible troubles.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.birmiss.com. Theme powered by WordPress.