How is the noise insulation of the VAZ-2114 made by yourself?

It's no secret that each vehicle is equipped with a special vibration and noise isolation from the conveyor. However, not all manufacturers provide their models with truly high-quality soundproofing. For example, the VAZ cars of the ninth model were initially distinguished by their low level of protection against noise and vibrations. And even with the release of the second generation of "Samara" (now it is model 2114), which was subjected to multiple technical updates, this situation has not changed. Therefore, these cars are modified by the car owners themselves. But how is the noise isolation of VAZ-2114 properly done and where to start? Let's consider.

Preparation for the process

In order to get to the desired element, we need a small set of tools for removing the skin. Only then we can see on our own eyes what it is, VAZ noise insulation. The VAZ-2114 has a not very complicated scheme of the cladding and fastening of the seats, so if there is an operating manual or even without it, you can cope with this work in an hour and a half. For those who want to provide themselves with the most silent interior, it is also recommended to remove the floor and ceiling covering.

Step-by-step instruction

First of all, after removing the upholstery, we pay attention to bituminous sheets. It is from them that all noise insulation of VAZ-2114 consists. If the sheets have a rough or wavy surface, they should be replaced. When the bitumen is smooth and without damages, no measures are necessary to eliminate it. From above on sheets we will glue an additional layer of noise insulation. But before doing this, regular parts should be thoroughly washed and degreased. The most effective means for this is ethyl alcohol. Also, this tool allows you to eliminate small traces of corrosion on the body of the car.

Next, we prepare a layer of vibration isolator for application. It is best to take a foil part - it is more effective in practice than all the others. We apply the material to the roof and door surfaces with an adhesive base of 1.5 millimeters. On the floor and the wheel arches should be slightly increased (up to 2 millimeters) this layer.

All accessible and prominent places of the car body are carefully glued insulators. When folds (ribs) appear on the surface of the metal, we pick up the roller and carefully roll the material over its entire area. So you will be sure that the noise insulation of VAZ-2114 was made at the highest level.

Then we apply a noise isolator over the freshly applied part. The entire application process is similar to the first, but here the thickness of the adhesive backing on the body must be 0.4-0.7 millimeters. Arches and trunk glue with a 0.8-mm base. You should also glue the wires. VAZ-2114 (white) often has a bunch of sibilant details on the door cards, which are constantly rattling and vibrating. Therefore, at the end of the work, we glue all the wires to the new noise isolator. Everything, at this stage, you can collect the salon back and ride the car for fun. By the way, the VAZ-2114 cooling system, which includes a radiator and antifreeze, will not influence the result of the work in any way, so do not be afraid to make soundproofing yourself.