HomelinessBuilding

Fixing parts as mandatory elements of modern construction

Modern construction is becoming increasingly large. Buildings in 25 floors - this is no longer a rarity, in larger cities there are also higher buildings. That is why it is so important to comply with security measures at all levels, starting with the first calculations of the future project, ending with external finishing. The folding part plays an important role throughout this process. It allows you to connect various supporting structures between each other, increasing the degree of their resistance to loads.

Materials fastening elements are diverse, it depends not only on the place of their use, but also on the further destination. To connect building blocks or high lanterns use metal, wood or plastic is used on less important objects.

In the construction use embedded parts made of high-quality steel of a certain thickness. If you changed the fixtures in your apartment, you noticed the pieces of wood that are installed in the wall. They are fixed in advance, so that you can then install the device. Plastic elements are used in the installation of swimming pools. These are specially prepared places, where different hoses will be connected in the future.

The production of embedded parts is affected by the purpose with which they will be used in further buildings. Their form is determined by the requirements of different standards. The main elements are metal plates and pins made of reinforcement. They can be interconnected, but sometimes the pins are replaced with bolts, thus a detachable connection is obtained . By the form of fastening elements are divided into open and closed. They differ in the number of sites. In the first case, we have a metal plate with welded rods. In the second variant on the ends of the pins there are additional metal plates. They allow more rigid connection between the building blocks.

In the direction of the pins, the embedded parts are divided into several groups. This can be a perpendicular arrangement of the rods or inclined, at an angle to the plate. The pins can be parallel or directed in different directions. The size of the plate and the length of the rods are determined by the brand of embedded parts. The metal base itself is made in the form of a rectangle or a square. Sometimes a rod with a loop or a ring is used instead of a plate, this form is more suitable if it is necessary to fix various communications.

The embedded parts are joined together by welding, glue or bolts. It can be a join in a brand or overlap. Each variant is interesting in its own way, but it follows from a specific place where the details are applied. If an adhesive joint is used, it is necessary to select the most suitable composition in the laboratory for the loads that are to be maintained.

When installing modern poles for street lighting or various supports, also use embedded parts. First, the lower part is fixed in the form of a pipe with a round or square flange. Then, the top mast is attached to it using studs or bolts. An anchor mortgage is distinguished by a base, it is made of a set of studs connected by a conductor from above and below. To ensure that all metal parts last longer, they should be protected from weathering. The use of a primer, paint or zinc coating allows to increase the service life.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.birmiss.com. Theme powered by WordPress.