A hood is an indispensable element of any kitchen, which ensures the cleanliness of air and the output of excessive moisture from the room. There are different types of presented devices. However, most often used hoods with ductwork. They are connected to a common ventilation system. Ducts for kitchen hoods can be of different sizes, material of manufacture, color and shape.
So, the produced elements can be made of plastic or aluminum. The second variant is represented by a corrugated pipe, which is connected at one end to the hood, and the other to the ventilation duct. It is cheap and practical. However, it does not fit very well into the general interior of the room, so such air ducts for kitchen hoods are installed in case they are in a closed nightstand. The disadvantage of the corrugation is that because of folds, it can not perform its work so effectively. However, it is mounted very quickly and does not require any special tools. But you need to pay attention to the fact that the metal was not too thin, as it will quickly break down.
Ducts for kitchen hoods made of plastic are attractive enough for design, they can have different shapes. In addition, such elements are very easy to clean, do not accumulate on themselves harmful bacteria. The only drawback of such products is that they can not withstand high temperatures and melt. In principle, in the home kitchen, there are rarely situations where excessively hot air (90 degrees or more) passes through the hood. Naturally, you need to choose such a device based on your individual requirements, as well as the conditions in which the object will be used.
Now you need to figure out how to attach the air ducts for the hood for the kitchen. In principle, this procedure is relatively simple, and you can cope with it without a specialist. However, all work should be done accurately and accurately. So, if you decide to use an aluminum element, you need to purchase special clamps to connect it with the hood and ventilation duct. Naturally, the corrugation should be chosen in the event that the neck of the main device to which the product will be attached has a round shape.
During installation, make sure that the clamps are tightened tightly, and the pipe itself does not have sharp bends that will make it difficult to drain the steam. Also it is necessary to pay attention to the fact that the ducts for the kitchen hood should be as short as possible. In this case, the efficiency of the cleaner is the highest.
The duct for drawing rectangular is also quite simple to install. The fact is that it is enough to install it on the cleaner and attach it with a yoke. It does not cause any difficulties. However, if the hood is in the wall, then the knee should be attached to the main duct. As for the shape of the neck of the cleaner, there are no problems here, since there are various adapters.