Corrugated walling. Application, Characteristics and Installation

In the modern market, a lot of new finishing materials have appeared recently. These include profiled sheeting. They call galvanized iron, stamped in the form of a trapezoidal profile. Above, such sheets are coated with a special polymer compound, which prevents corrosion.

Previously, this material was used only for the device of utility rooms - foraging, storage, etc. However, recently, thanks to improved technologies for making and painting sheets in bright, juicy colors, the corrugated board has become more and more often used for finishing living quarters.

Its main difference from siding is unconditional ecological cleanliness and very high durability. Produced as a wall profiled, and roofing. The difference of the first is that the wave height of the profile can not be more than 2 cm. On such sheets after installation, there are less loads of both mechanical and unfavorable environmental factors. Therefore, the wall panels are somewhat less durable than roofing panels .

Marked corrugated wall as follows:

• C10 - a universal sheet, which is used for both walls and roofs with a large slope of skates.
• C8 - sheet with a small profile height, used for fences, walls and ceilings.
• C21 - universal proflist.
• MP18 is a sheet having a sinusoidal profile (18 mm high).

Corrugated wall is used both for finishing walls, and for installing fences, the arrangement of temporary and utility rooms, as partitions, etc. The popularity of this material is explained by many qualities. As already noted, it is absolutely harmless to health. In addition, this material is distinguished by its high strength, durability and, importantly, ease of transportation and installation.

The installation of walled corrugated board, when using it as facing the finished wall, begins with the installation of leveling horizontal, perpendicular to the wall, brackets. After all of them are fixed, heat insulation sheets are installed. They are fixed on the wall with polyamide dowels. A windproof film is attached over the insulation . Then, to the brackets, leaving a small gap for ventilation, using vertical rivets attach vertical guides. Thus, the frame is obtained, which, in the future, will be attached to the corrugated wall board . The sheets are installed with self-tapping screws. The pitch depends on the type of profiled sheeting used. It is necessary to make fasteners so that the sheets rigidly hold on the guides.

When installing temporary rooms, cabins and other structures that do not require insulation, the fastening is made to the crossbars of the pre-installed frame, also through one wave, and vertically by rivets.

A wide range of applications, reasonable price and remarkable performance characteristics, distinguishing corrugated walling, made it the most purchased finishing material for walls and roofs. Galvanized and protected by polymeric composition, the surface of the sheets allows to significantly extend the service life. It is not less than 20 years. This is another remarkable quality that explains such a high popularity of this finishing material.