Wicket door and garage made of corrugated board

Durable popularity with the consumer in recent years has won such building material as corrugated board. It is readily used for fencing plots, building storage facilities and installing roofs. It is also in demand among car owners for the construction of garages. To build a garage from the corrugated board with your own hands, you do not need large material costs, in addition, the profile is easy to assemble, it is durable and wins externally due to a wide variety of colors. Covered with polymeric composition sheets of metal profile serve up to forty five years, they do not need constant coloring and special care.

Starting to build a garage from the corrugated board with their own hands is necessary from the foundation. It can be ribbon or columnar. The floor in the garage is made of concrete, with the simultaneous installation of a viewing pit. The basis of construction is a metal frame, the supports of which are installed at the time of laying the foundation and at the same time filled with concrete. After the perimeters of the future garage are supported, self-tapping screws are screwed to them. Sheets of corrugated sheet are attached to the frame by screws, and the correctness of their installation is checked by means of a level. To prevent scratching of the profile sheets, rubber pads are placed under the screws, and rivets are fixed with rivets to improve the sealing. The distances between the frame racks should be equal to the width of the metal sheet, which greatly simplifies installation and eliminates unnecessary work on cutting the profile. Garage from corrugated board is often insulated with mineral wool. You can use other heaters.

Garage of corrugated board, built with their own hands, involves the construction of a single or gable roof. The simplest, and therefore often used, is a one-pitch roof. On the rafters from the corner or pipes, which are installed simultaneously with the frame, self-tapes are fastened sheets of metal profile. After the profile is laid, all joints are sealed with a sealant.

Garage from the corrugated board is built quickly enough, almost every car owner can do it. One or two assistants are enough - and in a couple of days the garage will be ready.

As already mentioned, corrugated board is very popular for erecting fences, and since there is a fence, then a gate and a gate are needed. Wicket from the corrugated board with their own hands is attached to the supporting poles, which can be made of metal pipes or bricks. Pipes are installed in a pit not less than one meter deep and filled with concrete. If the pillars are brick, then under them an easy foundation is made. After installation of supports from pipes or a corner the frame of a gate is welded on beforehand planned sizes. In the middle of the frame, a pipe is welded. Awnings are welded to the finished frame, as well as to the poles and supports, and the lock is crashed into the frame itself. Profiled sheeting is fastened to the finished frame with screws, and in the place where the lock is installed, a hole is cut out. After installing the door handle, the wicket is hung on the support to check its operation.