We make a metal fence made of galvanized metal

As a rule, the general impression of a country house and its owners can be formed already after a first glance at the fence that surrounds the housing. Until recently, everywhere you could see shaky and ridiculous designs, made from improvised means.

Fortunately, the modern variety of building materials caused this anachronism to sink into oblivion, as it was replaced by a metal fence made of galvanized metal.

This material is made of high-quality steel, which is then coated with a layer of zinc, which effectively prevents the appearance of foci of corrosion. In addition, it is possible to purchase a colored corrugated board. In any case, you get a relatively inexpensive, but durable material. So, many manufacturers argue that the metal fence, with observance of the elementary rules of installation, easily stays up to 50 years.

Before starting work, it is necessary to properly mark the area. This is not too complicated, but it requires accuracy. Note that when marking places for pillars, you must adhere to the rule that the width of the span should not exceed four meters, and when mounting the fence in areas where there are often strong and gusty winds, it is better to completely reduce this figure to a half or two meters. In this case, your metal fence will stand even in the most unfavorable conditions.

Carrying out excavation works

It is believed that when the height of the pillar is 2.5 meters, you need to dig a pit for it, the depth of which is approximately 0.7 m. We recommend pouring columns with concrete, as this measure will increase the life of the entire structure many times. Only in regions with a mild and stable climate can one do without a simple ramming of the earth.

Making the frame

Further to the established posts, it is necessary to attach transverse veins. We do not forget that when welding, it is necessary to observe at least elementary safety precautions. It is very important to mark in advance the places where the crossbars are fixed, since otherwise the metal fence can come out very sloppy. Of course, that for the optimal accuracy of work should use a normal building level.

We fix corrugated board

After careful alignment and fixing of the crossbars, you can proceed to the final stage of the work. It is very important and in this case to constantly use the level and plumb line. If you are going to install a metal fence of painted metal, you should take care of its coating as carefully as possible, avoiding the formation of chips and excess holes, as they are the cause of corrosion. In the ideal case, it is best to process the edges of each fastener with a high-quality anti-corrosion agent.

If you use a Bulgarian, then the use of old and worn discs is unacceptable. This not only contradicts the simplest security rules, but also leads to the formation of torn edges. Beauty fence, they do not exactly add. In addition, all steps to shorten metal sheets must be carried out before they are assembled.

Thus, metal fences and fences are quite simple in their installation. Any construction worker who can perform all the stages of work as accurately as possible can cope with this.