Homeliness, Building
Roof overhang: preparation, material selection and process
To make the roof complete, you need to not only mount the roofing materials, but also make a filing of its hanging parts (eaves). Preparatory work for this begin at the stage of installation of rafters: the ends of the rafters need to be filed in one line. Pay attention not only to the length of the outstanding section of the rafters, but also to the angle of the saw: it must be parallel to the wall.
The next step, which requires filing overhangs of roofs, is the installation of a crate. She uses boards for her. They are mounted parallel to each other. The general appearance of the roof depends on how carefully the preparatory works are performed . To make the joint between the facade and the roof sealed, the overhang of roof overhangs is done before the installation of the heater. This ensures better sealing, which means a longer service life of the materials.
Selection of materials for filing
When adjusting the file, one should not forget about ventilation: the material must be protected from falling into the atmosphere, but it must necessarily have surplus moisture output channels, otherwise accumulating condensate will cause destruction of roofing materials.
Most often the filing of overhangs of roofs is made of corrugated board, lining (wooden or PVC) and soffit. Profiled sheeting is advisable to use if as a roofing material is taken tiles or the corrugated board itself. This material has good strength and guarantees high-quality protection against atmospheric precipitation.
It is a popular filing of roof overhangs by lining. When using a wooden lining, it should be chosen carefully: the wood should not have too low humidity, and the lining must be sufficiently thick (not less than 5-7 mm). PVC lining is the most economical option. Choose waterproof types and do not forget about plastic corners, which are necessary for processing joints.
The order of filing overhangs
Stitching overhangs of roofs from the lining is mounted to these laths. Using a soffit, a special bar is fixed, which is fastened with screws. Soffit sheets are cut into strips of the necessary width (it is equal to the distance between the mounting plates minus 6 mm for thermal expansion). Profiled sheeting with screws to wooden slats. To ensure ventilation, its width should be slightly (1-2 cm) shorter than the width of the overhang. All work requires accuracy, but there should not be any difficulties when observing the recommendations. You can, of course, entrust all professionals, but filing roof overhangs (the price is considered a square, besides, they are usually added for high-altitude work) is quite expensive.
Similar articles
Trending Now