Pulling the ceiling of the car with your own hands

In what cases is it necessary to tighten the ceiling of the car? In this article we will give an exhaustive answer to this question. In addition to the contamination of the fabric upholstery of the passenger compartment, associated with the ingress of dust, the color is still burning out from exposure to sunlight. Also, the problem of used cars is the sagging of the ceiling. This is due to the fact that at the factory it is glued to a special insulating layer. From it, after a certain period of operation, the fabric under the influence of different temperatures, humidity and vibrations peels off and sags.

Solve the problem quite simply. Pulling the ceiling of the passenger compartment with your own hands is the best option.

Benefits

Changing the interior inside your "iron horse" without resorting to help from highly qualified specialists, you can save time and money. Do not wait for your turn to do the work, pay more and worry about how good the result will be. And how nice it will be to see the creation of your own hands every day!

Materials

To update the upholstery you will need a cloth, scissors, glue, screwdrivers, rags, a knife. Since in each garage a large part of the listed inventory is always available, the perimeter of the car ceiling can be performed with minimal losses for the purse. I'll probably have to buy only glue and cloth. In order to understand the size of the material, before the ceiling of the car begins to be tightened, it is necessary to make measurements of the required area and add to them 20 centimeters for each side of the roof. The fabric needs to be bought corresponding to the interior of the cabin and stretchable. You can attach the material with glue "88", special in aerosol can and usual for shoes (it will need about 1.5 liters).

Preparation

Pulling the ceiling of the car with your own hands should be carried out in a place where there is no draft and heat. At the preparatory stage, you will need a screwdriver and possibly a knife. Preliminary having turned off all handles, peaks, plugs from plastic, clips and additional devices, it is necessary to remove an old covering. In this case, it is desirable to remember the order of the process, so that there are no difficulties when installing everything in its original place, when the ceiling of the car is over. When the ceiling is removed, you can see that it is based on pressed cardboard. The old fabric and foam rubber, with which it is covered, must be cleaned without leaving any bumps. By the way, if the body is "bared", then one can also engage in its noise insulation - an easy and necessary process.

Bracing

The lining should be installed on a large comfortable surface, for example, on a table. Pulling the ceiling of the car interior with your own hands should begin with applying a thin layer of glue. First of all, the fabric is applied to the front part of the ceiling, then it is pulled over all its forms. Excess material should be cut with scissors and, bent, glued to the back of the skin. After that, all the holes are cut.

Reverse installation

When the constriction of the car's ceiling is over, wait 3 hours. At this time, there is a process of tightening and adhering the tissue. After you need to carefully install the ceiling back to its place, twisting all the necessary details. Done! The interior of your car is updated.

When it is worth contacting specialists

Do not self-tighten the ceiling of the vehicle when the top airbags are activated. Performing this task requires certain skills and knowledge. A simple constriction in this case will not be enough. It will require the restoration of shape and additional reinforcement of fiberglass and epoxy. Only after this you can do a constriction of the ceiling. And still need to install new pillows.