Homeliness, Building
Mesh for plaster - the guarantee of structural strength
Probably, many of you encountered in life with repair or finishing, where you had to perform plastering walls. Technology, of course, is not very complicated, but
Previously, we used ordinary racks to create a framework. Time passes and materials change. Many people have a question: "Plaster or drywall?". Compare these two materials and talk about what is best and what is not, it will not be entirely correct. Each of these popular options has its advantages for a particular situation.
Grid for plaster: metal or fiberglass?
Today in the construction market quite often there are different options for the grid. And here the main thing is to choose the right one for your needs. The choice will depend, to a large extent, on the defect of the walls. If you have large uneven areas on them, and planned
When choosing a grid on a fiberglass substrate, there will be no difficulties, since it is not variable in composition. It is much more difficult to choose a metal analogue, because it is better for plasters when the cells are rhomboid. It is advisable to choose a mesh, which is covered with zinc, in order to avoid problems with rust.
Installation of a grid for plastering
In order for the plaster grid to be properly fixed, the entire surface must first be cleaned and primed. If a metal variant is chosen for work, then first you have to cut the material in separate pieces. Cut the fabric is necessary for the height of the wall, and the width is measured at its discretion, but the wider it is,
When the plaster grid is cut, you can start drilling holes that you need for dowels. In order to exclude sagging, you need to install them more often. The material should be found for 10-15 cm on the next cloth, then dowels are installed along these joints. At the final stage, special beacons are put up.
Glass-woven mesh for plaster is installed much easier than the previous version. You can stretch entire canvases, not cutting them into separate parts. For its fastening it will be enough to make an overlap and fix it with several screws. The main part will be strengthened when the wall is pounced on the solution.
Now you can proceed to the final stage - plastering the wall, but this is a different technological process. Of course, you will need a small experience in construction work, although this is within the power of everyone, if desired. Remember that the right choice of a grid for your walls is a guarantee of longevity and strength of the structure.
Similar articles
Trending Now