How to shorten a watch bracelet - practical tips

Buying a new watch, people often face the problem of a large bracelet or strap. To make it smaller in size, it is enough just to make an additional hole in the right place. But how to shorten a watch bracelet? The easiest way is to go to the workshop, where the specialist in a few minutes will fit the length to the required size. But you can do it yourself at home.

There are cases when the bracelet is purchased separately from the watch. To adjust the length in this situation, it is necessary, first of all, to install it on the clock. Without fitting it is impossible to determine whether it is worth removing links at all. Within the norm, a slight sagging is allowed, and the bracelet should not be adjusted.

Ways to adjust the length of the bracelet
Most bracelets have two types of length adjustment. First, you can shorten the clock in the simplest way and change the length of the bracelet by adjusting the lock. To do this, take out the latch of the lock with a simple click and move it to the hole closest to the latch. If the length has changed slightly, and the clock is still dangling, only the removal of unnecessary links will help.

We disassemble the watch bracelet

To accomplish this rather simple task, it is necessary to prepare a workplace and some tools: an awl, a nut, a hammer and pliers. Links in the bracelet can be attached to each other using pins, screws or pins. Pins and pins are dislodged or squeezed out when disassembling the bracelet, and the screws are twisted. Silo along the diameter should not be thicker than the hole in which the fastener is located. The diameter of the tool should not exceed the opening in which the fastener "sits". Instead of sewing, a gypsy needle, a compass or a drill suitable for a diameter is useful. How to shorten a watch bracelet in this case? To remove the fastener with a needle or a drill, you will have to strike with a small hammer.
Before starting to disassemble the bracelet, it is necessary to count the exact number of links to be removed from the lock.

How to shorten a watch bracelet and consider the number of links

Removing the links from the bracelet, you should remember about the need to observe symmetry, otherwise the lock of the bracelet will move to one side, which will cause inconvenience when worn. The number of elements suitable for removal depends on their size, and is usually limited to five or six pieces on each side. Decreasing the product is better to start from the third position, since usually the first two are larger in size. To shorten the watch's bracelet, it must be placed on its side, placing a nut between the links, combining the pin or pin, which must be removed with the nut aperture.
With the help of an awl, we squeeze out the connecting pin or pin. On the back of the bracelet, an arrow indicating the direction of movement is usually applied. Completely remove the fastener will help pliers. After the pins or studs are pulled out, it becomes clear how to shorten the watch bracelet. You just need to connect the remaining parts, making sure that the fasteners are seated tightly. Similarly, you can fit almost any bracelet in size. This is not a difficult thing, but it requires carefulness not to damage the clock itself.