Homeliness, Building
Self-assembly of sliding gates
Any owner of a private house wants to turn it into a real fortress. In this case, a very important condition is the availability of reliable gates. In a large number of regions of our country, the use of conventional swing gates can be associated with some difficulties, such as, for example, clearing snow in the cold season. Therefore, it is more preferable to use a sliding gate.
In the case of self-installation of this type of gate, you need to conduct a number of actions, the first of which is to purchase a set for sliding gates. Further, a concrete base is made. If sliding sliding gates are equipped with an electric drive, you need to make a competent wiring. After this, installation of the gate itself and connection of the drive are carried out. Consider the entire installation of sliding doors in more detail.
So, let's get started. The first stage of such work as the installation of sliding gates is the marking of the pit for the concrete base. In its length, such a pit should protrude on both sides of the gate about half the width of the passage, and its width - about half a meter. The depth of the pit must be greater than the average index of the depth of freezing of the ground, that is, not less than 20 centimeters.
Further, a mortgage element is made and dropped into the pit, which consists of a channel, to which parts of the reinforcement are welded. Such a design is lowered into the pit by the reinforcement downwards so that the channel is located parallel to the future movement of the sliding gates. After this, one or two support posts are prepared, the dimensions of which should exceed the height of the foundation by not less than 5 centimeters. After completion of the preparation of the pillars, the pit is poured with concrete.
After that, the end roller is inserted inside the supporting profile, and the fastening bolts are clamped. Then, from the back of the gate, a plug is welded to the bearing profile, which will protect it from various negative influences.
The next step is to install the guide bracket. To do this, the mounting of the bracket rollers is loosened, and it is mounted over the gate so that its rollers cover the upper part, and the guide bracket itself is directed to the opposite side from the support post. After determining the height of the mounts, the bracket is attached to the post.
The next step is to install the upper and lower trap.
And the final stage of such a very difficult procedure, like the installation of sliding gates, is the installation of all automation. All this installation should be carried out only according to the instruction, which should be complete with all the elements of automation.
Similar articles
Trending Now