LED spotlights for stretch ceilings (photo). Self-Installation

Lighting equipment is currently being given special attention with the appearance of a variety of types of lamps. Now often used LED spotlights for stretch ceilings.

Features of lighting fixtures

A common material for stretch ceiling is a PVC film stretched at elevated temperature and fixed in baguettes around the perimeter of the room. After cooling, the cloth stretches and becomes even.

Polyvinyl chloride has the ability to soften when heated. After installing the ceiling, the film should not be heated, as this will cause its temperature deformation, loss of form and even reflow. Hence the main requirement for lighting sources is that they should not give off excess heat when they are in working order. The power limit, at which there will be no overheating of the PVC ceiling, for an incandescent lamp should be 40 W, and for a halogen - 20 W. A little more resistant fabric fabrics. For them, the limits are 60 W and 35 W, respectively.

From the point of view of heat emission, the best luminaires will be LED, whose power is much lower for similar illumination.

Advantages of LED spotlights

The main advantages of LED lighting:

• Economical consumption of electricity;
• Small base;
• Minimum heating;
• High workmanship.

Overpriced can be considered the only drawback, but in any case, the dignity prevails.

What kind of spotlights to choose?

When choosing luminaires it is important to determine the purpose of their installation:

• Decorating the room with the correct arrangement of light sources;
• Additional lighting with the allocation of zones;
• The main light source.

Limitations on the body of the luminaire do not. It can be stamped products or aluminum alloys. Particular attention is drawn to the correspondence between the dimensions of the closed part of the device and the height of the interstitial space. Products can provide a gap of 2 to 12 cm. A large distance between the ceilings takes up a lot of space, which is unacceptable for apartment buildings.

Static devices provide illumination of a certain place, while rotary devices can change the direction of light. For additional adjustment of intensity of a light stream and color cardan models are applied.

When installing each luminaire on the ceiling, a reinforcing plastic ring is first glued on, and then a hole cutout is made inside.

LED spotlights for stretch ceilings with their own hands are installed neatly, otherwise, if the canvas is damaged, it will have to be completely replaced.

Other requirements:

• The edge of the point light should be chosen wider so that it is possible to hide the reinforcing ring;
• Under a single-level ceiling, lamps are selected with the direction of light strictly downward so that it does not dissipate behind the canvas.

Mounting fixtures

Arrangement of electric lighting and installation of supports for lighting is done in advance. After the installation of the ceiling there are support seats and reinforcing rings are glued to the outside of the web. When the glue dries, the inner parts of the film are cut out.

Through the holes in the rings, the height of the racks is adjusted so that they are at the level of the ceiling. To do this, the perforated profile is bent , from which the legs of the supports are made.

At the last stage, LED spotlights for tension ceilings are connected to the wiring, after which they are laid in the holes by compressing the spring clips. Inside, they diverge and are mounted on a support. Then the lamp is screwed. To make it ideally suited to the plane of the canvas, the post is finally adjusted.

Bathroom Lighting

The advantage of LED luminaires is reliable protection against moisture, lack of strong heating and safety of low voltage supply. LED spotlights for stretch ceilings in the bathroom is better to install recessed, as the wiring reliably disappears under the cover.

Rotary lamps are convenient for placing above the shower cabins to make the water procedures pleasant.

Fixed point fixtures are installed in a medium-sized bathroom in the amount of 4-6 pcs., And movable ones are placed to illuminate mirrors or lockers. For one lamp, a power of not more than 5 W is sufficient. The degree of protection IP 45 ensures the operation of the lamp at any humidity. Usually, there is enough level of IP 44, which protects the lamp from any splashes.

LED spotlights for stretch ceilings: reviews

Light sources on light-emitting diodes users in responses estimate basically positively. LEDs give an even and soft light, while there is no flicker, and energy consumption is negligible. Someone can not immediately get used to LEDs, but you should know that you can choose any color temperature. In addition, the controllers are sold for its regulation.

In numerous reviews, the originality of the devices and the acceptable price for LED spotlights for stretch ceilings are noted (photo below).

If not properly used, the LEDs can quickly fail. Especially they do not like overheating. When buying, pay attention to the quality of the radiators. With a slight overheating, the life of the luminaire may be shortened, and if it is critical it will immediately fail.

Sales specialists say that a small amount of information is provided about LED spotlights for stretch ceilings, and this is a brake on their wide application.

Interesting reviews about the use of LED sources with different brightness and color. The original glow intensity transitions create a special atmosphere. With other lamps, this effect can not be achieved.

Conclusion

With all the positive qualities, LED spotlights for stretch ceilings create special comfort, a unique lighting scheme with accents on important elements of the interior. This allows you to make a wide selection of models. In addition, LEDs are effective in combination with other types of lamps.