How to install electric tailgate

Probably, all faced with a situation when it is necessary to get something from the trunk or put in it, and the motor is wound up. The key to the luggage compartment, of course, in one bunch with the ignition key, so you have to either jam the motor, or with intricate movements to take it off the ligament. Today I want to tell you about how the electric drive of the trunk door is put on your car.

To do this, we turn off the weight of the car and open the trunk. We extract the piston lock from it, using a screwdriver, and then the piston itself. In the same way, we straighten out another three and remove the lock of the plastic lock. Using a 7 mm key, a threaded bushing is held, and the retaining screw of the rod is turned by a slotted screwdriver. When done, place the washer under the locking screw and wrap it. Next, the wire pull hook that comes in the kit is bent, so that the center distance is 20 mm. After this, it must be hooked on the locking screw, as well as behind the ear of the electric drive rail.

Now it is necessary to fix the electric drive of the trunk in the lid amplifier using two screws. He will calmly fit in the plastic casing of the castle.

Also, you can install the electric drive of the door, replacing the lock with a similar one from another car, if it is stronger. To do this, turn off the head all the stud nuts that are on the fastening of the lock to the trunk, in the amount that is provided for the design of your car, then it is removed. In its place we put an analogue. From the wire we make traction and connect the lever of the lock and the electric drive of the trunk behind the ear of the rail. Install it right next to the right lamp.

But be prepared for the fact that the power reserve of this electric drive may not be enough, and if severe frosts occur, the grease thickens and the voltage in the onboard power supply drops, the cover may not open. In this case, it is recommended to start the car and warm up the motor a little. During this time, the voltage is normalized, and the electric drive of the trunk should work. If this does not happen, then it will be necessary to warm it up.

The next stage will be power supply to the electric trunk. To do this, lay the wires through the luggage compartment lid so that they are parallel to the standard wiring harness. When you did, you need to bring them to the dashboard in the cabin.

Next, the button that will open the trunk crashes. For example, it can be installed on the floor of the tunnel. They often have a plastic cap, which must be removed. This will be a great place for your button, although it can be installed in another place if desired. Pay attention to the fact that it does not need to be fixed. Power must be supplied only when you keep it pressed. Otherwise, the electric drive may be rendered unusable.

Connect the tips from the power supply wires to your button and set it to the location you specified. Now turn on the mass and try to press the button. If you did everything correctly, the boot lid will open automatically when pressed.