HomelinessGardening

Fazenda's hotbed: customer reviews

Greenhouses are used for low heat-loving garden crops. With all the variety of design options, the principle of creating one: a skeleton is installed, and a translucent covering material is put on it. The basic requirements for greenhouses are simplicity, strength and convenience of service. Manufacturers constantly contribute something new in terms of improving the design. Not an exception is the newly appeared greenhouse Fazenda. Customer feedback indicates its popularity.

Elements of the "Fazenda"

Modern green materials are used in the construction of the greenhouse. Outwardly it is similar to similar devices, but it has its own characteristics.

Arcs

The main elements of the frame are arcs. The material used is HDPE pipe, which has been in service for many years. Lightweight and durable plastic is easily handled and bent. For the production of arcs the HDPE pipe is considered one of the best materials. It does not undergo corrosion, decay, frost damage and deformation in the heat. Arc colors do not require. The frame can be left to winter without dismantling.

Cover material SUF-42

For shelter in the greenhouse, a nonwoven fabric with an ultraviolet stabilizer is used. Porous material is produced in Germany. It is good for air and moisture.

An important indicator for a covering material is its density. The table shows the properties of the SUF-42 web depending on the density.

Density, g / m 2

Protection

42

From average frosts

60

From frosts to -5 0 С

80

From frosts to -10 0 С

If the density of the material is less than indicated in the table, it will not protect against frost, and its strength will decrease. With too thick material it is difficult to work, because it is poorly collected in creases, and clips do not hold it.

Pegs

They serve to fix and tension the greenhouse. When buying, you should pay attention to their length. Too short does not keep the greenhouse, and it does not withstand the wind. At the ends of the pegs there must be notches for reliable fixation in the ground.

Clips

Clips serve to fix the covering material on the arc in a certain position. They are small clips of plastic, put on an arc over the agglomerate. The design of the clip is not yet finalized. When the pressure is weak, it flies, and when it is strong, it tears the canvas. When buying a hotbed it is advisable to purchase spare clips.

The device of the "Fazenda"

The design is thought out to the smallest detail. The greenhouse is fully staffed, and nothing needs to be purchased for it additionally. Arcs are sewn into the covering material with a strong thread. Pegs and clips are included. The hotbed is pre-assembled, packed and enters the trunk of the car.

The minimum length is the "Fazenda" greenhouse 4m. Reviews say that it will fit even on a small bed, and use it comfortably.

How to install a greenhouse

It is convenient to collect Fazenda's greenhouse for two. This is done as follows.

  1. It is necessary to prepare an even bed under the greenhouse, dig it up, make the necessary fertilizers and materials to improve the structure of the soil.
  2. Carefully open the original packaging and get a hotbed.
  3. Insert the pegs into the holes at the ends of the arcs.
  4. Stretch the greenhouse over the beds and fasten the clips to the ends of the arcs.
  5. Install the ends of the greenhouse with the tension of the canvas, stuck the pegs in the ground.
  6. Install the internal arcs by fixing them in the ground in the same way.
  7. Insert the end pegs and attach the covering material to them, slightly pulling it.

To serve the Fazenda hotbed, the shelter from one side is raised and clamped with clips. After work on the bed, it returns to its original position in the reverse order.

Fazenda's hotbed: reviews

Reviews about the "Fazenda" greenhouse differ in their contradictions. Obviously, this is due to the conditions of its operation and the skills of consumers. Most notes compactness, ease, convenience of installation and use of the greenhouse.

The strength of the structure is affected by the absence of a longitudinal pipe, which should create rigidity. With a strong wind, the arc runs with staggering. At the same time, the clips are torn off and it is necessary to press the agglomerate with additional loads along the edges.

Clamps constantly fly and are lost. Therefore, many find suitable fasteners for drainpipes or paper clips. In the places pressed to the arches, the covering material wears out faster, it will not last long.

In general, such products as the Fazenda hotbeds are positive. It corresponds to the average level, but the price for it, according to many, is overstated. In this case, it is necessary to note original solutions in the design that attract buyers.

If you focus on the price of the Fazenda hotbed 6 meters, the reviews say that it is more profitable to take it than the 4-meter. Prices are very close, and 2 meters of closed ground will never be superfluous.

Absolutely identical products are produced under different names, for example, a greenhouse "Agronom", "Fazenda". Reviews and descriptions speak for the same design. Here, even the density of the covering material is 42 g / m 2 . With a large selection, you can prefer cheaper greenhouses.

How to make a greenhouse yourself

The Fazenda's greenhouse is easy to make by oneself. The HDPE pipe is sold in coils and can be purchased by measuring the required length. Then a pattern is made from the wire and all segments are cut on it in a step of 1 m. The length of the greenhouse is 4, 6 and 8 m.

At the base, the pipe is mounted on a metal rod that is clogged into the ground, or buried deeper. Above the entire length of the crossbar is skipped and fastened. Due to this, the design will be stronger than the firm one. To prevent sagging of the agglomerates, the arcs are connected with one another by twine. In this case, you need to provide that it does not prevent further care for the garden.

If you can not get reliable clips, the covering material should be spread over the frame and leave on each side an allowance for pressing the load. The best solution is to nail to the edge a long rail, on which you can then wind the canvas.

Option with clips is also possible. Only need to flush the covering material in such a way that it is possible to insert arcs into it at a distance of 1 m from each other. If it turns out to find separately accessories, then, according to users, the clips of "Bashagroplast" showed themselves well.

Conclusion

The "Fazenda" hotbed is described by buyers as an average product. The price is very high, but other models in this regard are also not better. With certain skills and desire, you can make a greenhouse like "Fazenda" with your own hands.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.birmiss.com. Theme powered by WordPress.