Battery maintenance: how to remove the battery

The driver is often lost and does not know what to do if his battery suddenly refuses to turn the engine starter and turns on the power unit. Naturally, you can push the car, use the "crooked starter", and you can go and buy a new battery. But if you know how to properly service the battery, then this situation by surprise is just not there.

This procedure involves periodic charging of the battery, which is the most economical and effective way to ensure the guarantee of starting the engine. Self- charging is a very easy process, and Anyone can do it. True, there are some rules that you should not break.

To begin with, you need to solve the problem with how to remove the battery. To disassemble the battery from the machine, it is necessary to disconnect the battery terminals to prevent short circuits. This will save the wiring from breakage, and in some cases from ignition. When answering the question about how to remove the battery, it is worth noting that you first need to disconnect the negative battery cable.

If the battery needs to be pulled out of the engine compartment, then it is necessary to disconnect the plus cable and unscrew all fasteners. So, with how to remove the battery, figured out now what to do next.

The first step is to prepare the battery for the charging procedure. It is worth noting that it is not necessary to remove the battery from the car, but in this case, all going To it, the wires must be disconnected. The chemical that is inside the battery must be able to access fresh air, for which the protective bolts are removed or the lid is removed.

When asked about how to properly maintain the battery, it is important to note that the level of fluid in it plays an important role, and therefore it needs to be monitored. If the liquid does not suffice to the required level, then it is necessary to add distilled water or electrolyte to the banks of the battery, it all depends on the capacity of the liquid. If you ignore the procedure, then the plates inside are simply burned, and the device will lose the ability to keep an electric charge.

After servicing the battery, it must be connected to the charger, while the power on the charger itself must be turned off. When all the wires are connected to the corresponding circuits, you can plug into the network.

Qualitative and correct charging will be performed when the current The charger will be set to minimum. In this case, AKB will be able to keep the charge in it for a long time. When the battery level in the battery reaches the required value, the battery can be disconnected, wiped, and the protective cover back installed.

When the charging procedure is completed, the battery is installed on the vehicle. All actions are similar to how to remove the battery, only they are made in reverse order.