How to draw water from a well into the house: recommendations

In some cases, it may happen that a separate supply of water is required to the house. This is especially common in the villages. In this case, there is hope only for a nearby well. Very well, if it is located in the courtyard, in this case there is no need to run around all the time with buckets, and it becomes possible to organize a water pipe. And then the question arises: "How to draw water from the well into the house?" It is necessary to understand with it.

So, if we talk about how to draw water from the well into the house, it is worth mentioning what it might require. You will need: a pump, wires, pipes and a heater. And now you can understand what and how to do with it. To begin with, you need to take care of purchasing a sufficiently long pipe, so that it gets from the well to the house, that is, up to that place inside, to which water is supplied. It should be bent accordingly, that is, to approach the terrain, if necessary, you can use the supports.

Talking about how to draw water from the well into the house, it is necessary to say about the necessity of placing along this pipe another one, through which the electric wire for the pump will pass, otherwise you will not manage to organize the water supply. You must necessarily reliably and qualitatively insulate both pipes, so that they are immune from freezing. The degree of insulation and the amount of material used depends on the area in which you live, that is, from the frosts typical for this area.

Finding out further how to draw water from the well into the house, it's time to say about the necessity of placing an electric pump in the well. To do this, it should be lowered down. It must be connected to a pipe through which water will be fed into the house. Then you must fix its position using a wire or a rope. After that, you can connect the pump to electricity by using a wire that you failed earlier.

When deciding how to draw water from a well, it is worthwhile to understand that the pump should be placed so that, if necessary, it can be easily turned off and pulled out. It should not work in too much cold, as the surface of the water in the well can be covered with ice, which will certainly cause the pump to deteriorate.

Since water from the well to the house is fed by the operating device, it is necessary that it be equipped with an auto-lock that protects it from overheating. In the event that the water level in the well falls, the pump will overtake the air, which can cause its overheating. It is in this case that the equipment will be rescued by a blocker that turns off the device when it reaches a certain temperature.

It is important to remember about such a moment as water purification. Here it is worth saying that in well water there are a lot of impurities that cause clogging of pipes and damage to sanitary ware. There is not one filter that can cope with all kinds of impurities. That is why the cleaning should be multi-stage, that is, you must install several filters designed to get rid of various impurities.