How to configure a local network: a few tips

Sometimes it happens that you need to move files from one computer to another, or there is a desire to play a network game on two mates. And here the question of how to configure the local network is quite natural. Further we will talk about this.

First of all, it is important to determine what will be required to create a network and install it:

• A pair of computers;
• Presence in each of the network card;
• A network cable designed to connect these devices. From both ends it must be compressed by connectors;
• A switch that you may need if your goal is to connect more than two computers. This device will combine existing network cables into a single system.

Now you can consider the question of how to configure the local network. In this case, each action should be described in as much detail as possible. First of all, you need to check the settings of the workgroup, because computers determine each other only if they are located in the same group. If the names are different, you should bring them to the same form. Next, go directly to the settings. In the My Computer menu, find Properties. The name of the working group is changed in the tab "Computer name". Here you can not only change the name of the workgroup, but also the name of your device, under which all others will see it. If you talk about how to configure the local network in the case when the cable was connected before installing the operating system, it should be noted that the network itself will determine without any difficulties.

Another case is the problem with the definition of the network, in which case it is necessary to restart the computer, which will start the process. If this does not happen, it is quite possible that you will be interested in the question of how to configure the local network yourself. In this case, too, there are no difficulties.

You will need to enter the "Connections", find the "Network Management Center", and there you will find "Viewing the Network Status". Next, select a network card to change its settings. In the "TCP / IP Protocol" section you must enter certain parameters. There are no difficulties. The address is required to write 192.168.1.X, and the subnet mask should be 255.255.255.0. This is all about the question of how to configure the local network through a router.

Sometimes there are problems if you combine computers with different versions of the operating system, for example, Windows 7 and Windows XP. Here, just as in the previously described situation, it is important to observe the name of the group and each computer. To make the configuration complete, you should make a folder that should be shared, accessible to both computers.

If you need to create a local network via the Internet, then it is important to know that this is done with the mandatory use of specialized programs, as standard means to implement this is not possible.

So, here it was considered how to configure the local network in various ways. In most cases, the above principles may well be universal.