Gas columns "Astra": specifications and reviews

Gas columns "Astra" are produced by the Russian company "Heat exchanger". In the market the represented company exists more than 50 years. The columns "Astra" for hot water supply are intended. They are used exclusively on natural gas. In this case, the combustion products are quickly removed through the chimney. Earlier, the company "Heat Exchanger" was engaged in the production of water heaters of the KG series. However, to date they are considered obsolete. Modern devices of the "Astra" series have a lot of advantages.

First of all, it is important to mention the large combustion chambers. Power of some models reaches 20 kW. The performance of the speakers is different. At the same time, their natural gas consumption is moderate. In the installation of the model are quite simple. Chimneys on gas columns "Astra" are installed with a diameter of up to 120 mm. The average model on the market is about 9 thousand rubles.

The parameters of the model "Astra 08" (HSV 8910)

The power of this column equals 12 kW. If necessary, the user can adjust the thrust. The maximum heating temperature is exactly 60 degrees. The thermostat in this case is installed at the bottom. The smoke exhaust path of the model is quite wide. The burner of the column shown is located under the central union.

The pressure regulator is available for the model. The frame is used rather sturdy, and the load is capable of withstanding large ones. For the battery, the manufacturer provides a separate container. The protection system he has. To adjust the position of the clamping nipple there is a special screw.

Reviews about the device "Astra 08" (HSV 8910)

These gas columns "Astra" reviews are positive. In this case, the natural gas consumption is 2 cubic meters. Meter per hour. At a power of 12 kW this is considered normal. The urge to check with the model is quite simple. If necessary, you can watch the temperature. The pressure regulator is installed quite high quality. Combustion products are always removed quickly.

In general, this column is safe, and does not pose a risk to human health. According to the owners, this gas column "Astra" has a solid frame. The instruction is included in the standard kit in detail. Many also note the low price for the goods. To date, the model user is able to purchase for 7 thousand rubles.

Possible malfunctions "Asters 08" (HSV 8910)

The burner is used for a good model, but the economizer under it can periodically fail. This happens often due to malfunctions with the wiring. To repair the gas column "Astra" with their own hands, first of all you need to cut off the gas. In this case, it is not necessary to remove the device from the wall. To disconnect the front panel, you need to use a screwdriver. There is an economizer behind the electrode.

In order to get to it, first of all you should deal with the block. The electrode in this model is mounted on four screws. The heat exchanger in this case does not need to be touched. After removing the electrode, it is important not to touch the pressure measurement connector. Otherwise, his head will have to be changed. Removing the economizer is quite simple. To do this, unscrew only the two screws that are on the left and right side. Then you need to check his contacts. In some cases, they become dirty after a prolonged use of the column. If this does not help, the economizer will have to be replaced. Then it needs to be installed behind the electrode again. If after that the gas column "Astra 8910" is not lit, repairs can not be made by oneself.

Characteristics of the column "Astra 10"

This gas column "Astra" has the following technical characteristics: the maximum power is 15 kW, and the maximum temperature is 65 degrees. The ignition in this case is carried out manually. If we talk about the design features, the burner is located at the adjusting screw. The pressure gauge is installed in the model. Thermostat in the design is also provided. There is a separate container for the battery.

The ignition module of the model is located near the hydraulic group. The dimensions of the column are very compact. The gas is connected through a tube with a diameter of 3.4 inches. In this case, the system can withstand water pressure of 6 bar. The natural gas consumption is 2.1 cubic meters. Meter per hour.

What do they say about the model "Astra 10"?

This gas column "Astra" reviews from consumers deserves the most diverse. First of all, the owners appreciated the simplicity of the design. The thermostat is convenient for the model. If desired, the thrust is adjustable. The pressure of the water system can withstand a great deal, so you do not have to worry about the path. Also, the column has a good economizer. The temperature controller is simple. Acquire gas columns "Astra" of this series the user is capable for 8200 rubles.

Repair of the column "Astra 10"

If the gas column "Astra" does not light up, you can try yourself to understand the cause of the failure. To do this, remove the front cover, which is fixed to the screws. After this, you will have to inspect the heat exchanger. If there is dirt on it, it should be removed. Then you have to disconnect the electrode. In this case it is important to comply with all safety rules and not risk your health.

Doing repairs of the gas column "Astra", the pressure measurement connector can not be touched. It can only be inspected by a service technician. However, the operation of the hydraulic group of the column can be checked independently. To do this, remove the four screws. In this model, the economizer is out of the way, so you do not need to touch it. The burner itself should also not be inspected. To ensure that the hydraulic group works, you should consider its gas valves. They are fixed on the panel firmly.

If there is dirt on them, it must be carefully removed. After this, the hydraulic group should be replaced. Gas valves in this case should look at the rear panel. If the column does not turn on after the procedures, the model will have to be handed over to a service center for repair.

Characteristics of the device "Astra 15"

This gas column "Astra" has the following characteristics: the power of the model is 13 kW, and the productivity is 12 liters per minute at 25 degrees. The combustion chamber is open type. The ignition is done manually. The minimum temperature of the column allows you to maintain at 35 degrees. The natural gas consumption is equal to 2.2 cubic meters per hour. Cold water is connected through a 1.2-inch pipe. The chimney in this case is provided for 120 mm. Weigh the assembled model exactly 15 kg.

Opinion of consumers about the model "Astra 15"

This model reviews from buyers basically gets good. The device of the gas column "Astra" pleases many, since the parts are of high quality. Also, the owners celebrate high productivity. By design, the model is simple. If necessary, you can adjust the temperature. The water pressure system can withstand as much as 7 bar.

Chimney in the presented construction is fixed securely. Also, a solid frame should be added to this. A hot-water bottle at the model is provided qualitative and breaks very seldom. It is also important to mention the thermostat, which is installed at the bottom of the column. The protection system is provided for it. To date, these gas columns "Astra" are sold at a price of 8500 rubles.

Possible malfunctions of "Astra 15"

Despite the positive feedback about the model, it periodically breaks down. If the gas column "Astra" does not light up, you must first determine the cause of the failure. Make a superficial inspection of it is possible only if you remove the front panel. To do this, you need to use the key. After unscrewing the screws and removing the panel, you can inspect the heat exchanger directly.

In this model, it is located under the tract. The electrode in the device is installed high-quality, but periodically its contacts become dirty. In order to clean them, you have to completely remove the box. It is fastened to the screws, so without a key in this situation can not do. The adjustment valve is missing from the model. Only specialists can inspect the control unit.

The last thing to check is the hydraulic group. It is removed quite simply, but it will be difficult to fix it to its former place. Before removing the box, this should be taken into account. After disconnecting the hydraulic group, it is important to inspect the gas valves. If they are installed unstably, then the part will have to be completely changed. You can do it yourself. To replace, you will have to purchase a similar hydraulic group. In this case, you only need to remember the column model and inform the seller.

Overview of the model "Astra 16"

The power of the model is 18 kW, and the capacity is as much as 14 liters per minute at a temperature of 25 degrees. In this case, the diameter of the chimney is 110 mm. Water pressure system can withstand no more than 5 bar. The natural gas consumption is about 2.1 cubic meters. Meter per hour. Weigh the collected column of only 14 kg. The cold water is connected through a pipe, the diameter of which is 1.2 inches. The maximum heating temperature is 65 degrees. The combustion chamber at the column is open type, and it is ignited manually.

Customer feedback on the model "Astra 16"

The owners often respond positively to this column. The power of many suits, and the performance parameter is also at an altitude. The consumption of natural gas is slightly overestimated, but the maximum temperature of the water accumulates quickly. Disadvantages of the column is also there. First of all, it is worth mentioning the small pressure parameter that the valve can withstand. In some cases, the burner may break.

The adjusting screw at the column is durable. There is no container for the battery in the sample presented. It should also be noted that this column is produced with a small ignition unit. Hydraulic group breaks rarely. You can buy this column for 9200 rubles.