Homeliness, Building
We learn how to stack bikrost
The roofing material largely depends not only on the safety of the truss system, but also on the entire roof and the house itself. Considering the cost of materials for repair, it is better not to save on it.
What it is
The material is relatively new, appeared on the market only in the 90s. In our country, many builders do not know about its existence to this day. In essence, it is a fiberglass, on which a substance based on bitumen is applied. Thus, the roof of the bicrot is completely waterproof, resistant to flame and low temperatures.
What we need
- The material itself;
- Primer bituminous;
- burner.
Preparation for work
Before laying bikrost, it is necessary to thoroughly clean the surface of any contaminants. It is necessary to eliminate all existing irregularities, remove all sticking nails and fittings. Large depressions and splits need to be sealed with cement mortar, or replace damaged parts of the roof.
"Improvement" of the roof
Since it is necessary to lay bikrost on a high-quality surface, it is more expedient to improve it, which will promote better fusion of the material. It is best to cover the roof throughout its entire length with a bitumen primer, which will tighten all the cracks and minute pores. Once recommended to use for this purpose ordinary bitumen, diluted with gasoline, but the danger of such a composition can not speak ...
After pounding, wait a day or two until the mixture is completely dry.
We lay
If your roof has a slope of 15 degrees or more, then the bikrost (how to style it, you will soon learn) should be rolled along the rafters' direction. If the slope is less, you have to close the roof in all directions. Rolls need to roll out on the roof, then fit in the size you need. After that, the rolls roll down again.
Fusing
For its unwinding it is more convenient to use any stick or poker. We ignite the burner, after which we carefully unfold the roll, gradually warming up its lower layer. The movements of the hand should be as smooth as possible, otherwise it will not achieve the desired uniformity of melting.
The rolls are stacked so that the edges overlap one another at least 10 cm. In this case, the quality of the waterproofing will be much higher. During work, walking on the material is not recommended. In the joints it is better to press the layers together.
That's how to stack bikrost. If you comply with all the above rules of installation, the roof of it can serve you more than a dozen years, almost without requiring any attention. Repair will also be needed very soon.
Similar articles
Trending Now