Some recommendations on how to tie off mormyshki

Often during fishing, mormish is lost. Even though the fisherman has a strong line, it can fail at the most inopportune moments. Therefore it is very important to know how to tie mormyshki.

Experienced fishermen know that when, for example, a big bass pecks, it renders all sorts of resistance while dragging it into the hole. It also happens that a pike with very sharp teeth is caught, and there is no trace left of the mormish. That's why you should have an idea of how to tie the mormyshk correctly. Of course, in the arsenal of bait, every lover of fishing has everything you need, but if it's frosty outside, then adjusting the new mormyshka with your bare hands is a laborious procedure. In addition, it is necessary to implement this after the cliff very quickly, so that the bitten fish, as they say, did not go away. It is important to throw a new mormyshk into the water without delay. The line, as a rule, terminates at the tackle attachment point, and not somewhere in the middle. The deformation of the line is often due to its rubbing against the edge of the mormish, despite the fact that it has increased strength. Minimize the likelihood of this problem can be in the case of mastering the skills of how to tie mormyshki.

Every amateur fisherman should know that the less deformation during the fishing line tying, the less the risk of its breaking. At the same time, it is necessary to learn how to tie a fishing line correctly: as little as possible to bend and bend it less during the tightening of the knot.

So, how to tie mormyshki?

A line of ten centimeters is passed through the hole from below. This part is then transformed into a two-centimeter loop, which is then pushed along the hook's forearm and fastened with a thumb and index finger. Next, make five turns of the tip of the line around the loop and fore-end. Then the free tip of the remaining line should be passed through the loop. The next step is to tighten the knot at the end of the line. In this case, it is necessary to tighten the knot at the tip of the line, rather than on the main part, otherwise the mormyshka can deform. Mormyshki for winter fishing are attached in a similar way.

Over time, you will acquire the necessary skills, and this procedure will be implemented in a matter of minutes.

If the mormyshka is made of solid tungsten, the line can deteriorate due to friction against its sharp edges. To minimize the possibility of this problem, it is necessary to insert a cambric into the aperture of the mormyshki, and then through it to thrust the line. This flexible and soft material will protect the line from friction. However, do not forget to periodically re-bandage wrinkles.

At the same time, the winter mormyshka also needs protection from rubbing the fishing line.

It should be noted that at the present time among fishermen mormyshka as a kind of tackle has gained unprecedented popularity, because in this way it is possible to fish a huge amount of various fish.