How to make an aerosleigh with your own hands

Can I make an aerosleigh with my own hands? Let's look for the answer to this question. Are there any reliable aerosleighs with their own hands made right at home? Not everyone is ready to trust their hands and what he can do himself.

Homemade aerosleighs are a very interesting form of transport. The fact is that they are moving at the expense of an air propeller, in the people it is also called a propeller.

Most often the design of the aerosleigh is three-ski. Sometimes there is also a four-legged one, then you can move on them not only in the snow, but also on the water surface.

Imagine, as you rush through the snowy plain faster than the wind, you get up the whirlwind of snow - all this is possible and real, if you have an aerosleigh. It is very convenient, high-speed, and most importantly, a simple mode of transport. Anyone who is equipped with the technique "on you" will be able to build an aerosleigh with his own hands.

Consider how to make them yourself. The material is a tree. The construction will be three-track. The longitudinal beam of the body and the transverse one, on which we will attach the back skis, will be made of pine bars. Take bars measuring 35 to 40 mm, they will be fastened with bolts. Pay attention to the docking nodes, there you need to install metal angles, as well as washers, necessarily large diameter, as they will prevent the crumpling of the tree.

Where a turntable for the front ski will be installed, as well as where the engine and the rear skis are fastened (ski suspension), braces, metal plates and squares should be provided. The ski is again wooden. The body, more precisely its front part, it is necessary to quote. On the hood you can install a bicycle headlight, and on the sides - metal footboard. Seat for the driver can be made from a piece of plywood about a millimeter thick 8. The seat must rest against two springs, which we borrow from the saddle for a bicycle. It is important to pay attention to the fact that the bars securing the engine must be of different lengths. The rear bar is longer, it will serve as a fence against the propeller.

On the back skiing you need to make the so-called staples-hogs, you can make them from strips of steel size 30 to 5 mm. Skiing should be collected with the help of three plates of plywood, which should be approximately 4 mm thick, they will be fastened with casein glue. Plywood at the edges should be reinforced with bars, preferably oak. The soles of skis should have longitudinal cuts, and they must be fenced with sheet iron. This is to ensure that when you stop the aerosleigh not drowned in the snow. The front ski (its turn) will control the aerosleighs.

We will have a cable transmission from the steering column. To control the engine, it is necessary to build levers: the gas lever and the ignition timing lever. Wiring is borrowed from a motorcycle, it will be either a cable or wire, but always in a flexible shell. The engine will be a launcher PD-10 from the tractor, on it we install a cylinder for air cooling, also from a motorcycle, for example from IZh-56. Above the engine, install the fuel tank. The fuel will be supplied by gravity. That's all - before you aerosleigh self-made. They can be cut through snow-covered fields or simply over snow-covered terrain. The main thing is to do everything on conscience, firmly and accurately, in no case your vehicle collapsed during the movement. As you can see, you can make an aerosleigh with your own hands, you just need to make efforts.