How to beat the braid correctly

Despite the fact that recently there are new modern mowers and trimmers, many still use the usual hand braids. After all, in order to just remove the grass under the trees and along the fence, to spend money on newfangled means is completely useless. It will be quite enough and the simplest grandfather's plait on the cuttings. However, this tool also needs some care.

Over time, the blade is dull, mowing becomes quite difficult. Of course, you can sharpen it with a bar. But a stable result in this case is difficult to obtain. After an hour and a half work, he again requires sharpening. Therefore, many gardeners and gardeners often raise the question of how to repel the braid. The case is quite simple technically, however it is very time-consuming and requires accuracy. If the approach is incorrect, the tool can simply be spoiled. Therefore, usually in this case, refer to a specialist. However, if you are confident in your abilities, you can try to do it yourself.

First of all, you will need to prepare tools. You will need an old file, a regular stump or a log and a hammer. With the first tool, remove the handle and cut off the adjacent part of the canvas in such a way that there are five centimeters left. The edge of the piece will need to be worn out. In the end, he must take the shape of the semicircle in the profile. This is necessary in order to repel the braid and give the blade the desired shape. The heel of the hammer is grinded until it becomes absolutely flat. A conventional tool can not be used.

So, how to repel the braid? A prepared piece of file is driven into a log tree. To fix it better, you can use a nut. If desired, you can use a small anvil. But in this case you need a special hammer. Then the blade is removed from the braid. To do this, you need to knock out the fastening ring. Sometimes it is twisted on the nut. In this case, the latter is preliminary, of course, untwisted. Then a wedge is taken out, as a result of which an uncomplicated design is disassembled.

To understand how to repel a braid professionally, you need to look at its blade. In the end, it should have a small notch along the edge. For this purpose, the corresponding shape was also given to the profile of the file. The blade is placed on the beaten file edge, absolutely horizontally and begin to gently tap on it with a hammer. Coverage Area Thus it should not exceed two millimeters. For convenience, it is possible to place a bar of the same size as the anvil under the opposite end of the blade. Experts advise: it is better to hit several times, but neatly than one, but strongly. Beating is necessary, slightly pulling the hammer together with the metal on itself. From time to time it must be moistened. The result should be a thin and very sharp edge.

Thus, the blade is processed along the entire length. As a result, the edge does not get absolutely flat, such as, say, a knife. There are always small notches. Eventually, a kind of micropyle comes out, which cuts the grass very well. Thus, it is clear the answer to the question of how to properly repel the braid. The edge must not just be repulsed, but drawn. On the reverse side, the required groove is obtained. Everything must be done very carefully.

Then the blade is put back on the shank, a wedge is inserted and all this is fixed by a ring. The tool is ready for use. We hope, now you are more or less clear how to repel the braid.