"Crosser" (motoblock): description, features, spare parts, views and reviews

The company "Cross" motoblocks in recent years are in great demand. Transmissions at them basically are made ременьного type. On average, the power of diesel-powered motor blocks does not exceed 5 kW. The fuel consumption in the devices is quite different.

Motors in motoblocks are installed, as a rule, three-stroke type. Not all modifications are suitable for processing hard soils. It is worth in our time a good model of the represented trademark in the region of 55 thousand rubles.

Types of devices

First of all, the devices differ in type of engine. On the market there are modifications with asynchronous and three-act devices. The cooling system is used in air or water type. Small modifications are made with asynchronous type engines. The limiting frequency of the motor blocks of this type does not exceed 5 thousand revolutions per minute. Large models are often equipped with three-stroke engines. The limiting frequency of the motorized blocks of this series does not exceed 6 thousand revolutions per minute.

What spare parts are needed for the motoblock?

By completing the model pretty much otschayutsya. First of all, the devices need replacement spare parts from the standard kit. In this case, we are talking about a longitudinal milling cutter, a plow, and also wheels. Still at motoblocks enough often go out reductor coils. Spare parts for the motor can always be purchased at a specialized store or service center. The cost of the goods depends on the type of the part, as well as on the features of the model.

Model Description CR-M2

These are inexpensive and high-quality motoblocks "Crosser". Spare parts for them to get in the store is quite difficult. It is also important to note that the model uses only one plow. The wheels of the motor block are of small diameter. However, their patency is normal. For soil cultivation the device is suitable normally. Reducer in the model is hammered very rarely.

The motor overheat protection system is used in the third class. If you believe the feedback of buyers, then the clutch is working fine. The width of the plow in this case is exactly 90 cm. To start the engine, a contact starter is used. It goes out of the system very rarely. The stroke of the piston in the motor block of the presented series is only 77 mm. Buy a model in the store of agricultural equipment can be priced from 59 thousand rubles.

Customer feedback on the device CR-M1

These motoblocks "Crosser" reviews from buyers mostly get good. Owners appreciate the device for a durable plow. In this case, the motor is used in a three-stroke type. In total, the model has two cutters. If desired, the plow is removed without problems. The drive of the motor block is of the belt type. The transmission is designed for five speeds.

Cooling in the motor block of this series is of the air type. To fill the device uses diesel of any brand. Together with the plow, the motoblock weighs approximately 230 kg. The power of the modification is 3.5 kW. In terms of size, this motoblock can be called quite cumbersome. For large land the device does not fit the best way. Firms "Cross" motoblock CR-CR-M1 can be bought at a price of 48 thousand rubles.

Customer Reviews of CR-M5

This is a universal and high-quality motoblock. Spares on it are cheap. It is also important to note that the kit includes an excellent plow. The performance of the equipment is quite high. The stroke of the piston in the motor block of the indicated series is at the level of 87 mm.

The motor overheat protection system is used in the second class. If you believe the feedback of buyers, then the reducer is able to withstand heavy loads. In order to launch the model, a contact starter is used, which works instantly. The cooling system is of the air type. For the purpose of processing large areas, the device is suitable. Also the model is often used by summer residents. However, the drawbacks of the motoblock of this series still exist. First of all, this refers to weak adhesion.

Disks from the gearbox have to be changed frequently. The tank in the device has a small volume. Water cooling at the motor block by the manufacturer is not provided. On solid soils the model is moving very hard. Buy motoblock "Cross M5" in the store of agricultural machinery can be priced from 63 thousand rubles.

Characteristics of modification CR-M7

The presented heavy motoblocks "Crosser" reviews tend to get good. First of all, this model is appreciated for high engine power. In this case, it is applied in a three-stroke type. In total, the motor block uses two plows. The height of this unit is equal to 92 cm. The engine's engine capacity is exactly 340 cubic meters. See The cooling is set to water type. The drive is belt driven.

If you believe the feedback of buyers, then the gearbox of the model is protected well. The starter is of the contact type. The stroke of the piston in the motor block is 88 mm. The tank in this case is located at the rear of the structure. The working speed of the motoblock is a maximum of 19 km / h. For cleaning large areas, the device does not fit well. The oil tank of the motor block of the specified series is set to 5.5 liters. Buy this model can be for only 61 thousand rubles.

Model Description CR-M8

Motoblock "Cross M8" has a lot of advantages. Among them, it is important to mention the quality wheels. The plow in this case is difficult to remove on its own. It is also important to note that the model uses a rather weak rack. The cleaning filters must be changed periodically. The maximum power of the power unit is 4.3 kW. Buy the specified model to give the user is able to price from 48 thousand rubles.

Customer Reviews for the CR-M11

The company "Crosser" diesel motoblock CR-M11 is produced with an asynchronous motor. If you believe the feedback of buyers, then it starts quite quickly. Of the features of this model, it is important to note the great weight, as well as the wide plow. The height of planting is average. If necessary, the cutter on the device can be removed independently. In this case, the volume of the engine is 388 cu. See Weights motoblock represented by the series only 270 kg.

The oil tank at it is in the bottom part of a design. The stroke of the piston at an average speed is not more than 47 mm. The working speed of the equipment is 12 km per hour. The transmission is used with the belt unit. The maximum power of the motor block is 3.3 kW. The drive in the device is of the belt type. The minimum power of the power unit is 1.2 kW. In the standard modification kit, there are three plows to choose from. In this case, the minimum operating speed is 2 km / h. If necessary, you can sharpen the mill yourself. However, it is important to note that it is sometimes very difficult to establish it in its original place. Separate attention in the device deserves a starter. In this case it is of the contact type. The maximum frequency of the motor block is 4 thousand rpm.

For the suburban areas the device is not bad. The cylinder diameter of the modification is 30 mm. The oil tank at the motor block of the presented series is designed for 4.5 liters. If you believe the feedback from buyers, the transmission works well. Disks in this case wear out very slowly. For cultivation of hard soil, the device fits perfectly. Buy the indicated motoblock (diesel) "Crosser" in the store of agricultural machinery can be priced from 57 thousand rubles.

Consumer Opinions on the CR-M6E

These cultivars are often used to cultivate farmland . In this case, the milling cutter is of a small width. If you believe the feedback of buyers, then the plow height can be adjusted quite simply. The cutter is connected to the motor block without problems.

The drive in the device uses a belt type, and the engine is installed three-stroke. The maximum power of the motor block of this series is 4.4 kW. The cooling system is of the air type. In total, the model has two nozzles. Trade mark "Crosser" motoblock CR-M6E can be purchased at a price of 59 thousand rubles.

Characteristics of modification CR-M8E

This motoblock has rather good characteristics. The nominal power of the model is as much as 4.4 kW. It is also important to note that the limiting frequency is at 4,000 rpm. The stroke of the piston at maximum power is not more than 82 mm. The motor overheating protection system is applied in the third class. The motoblock of the presented series weighs 180 kg. The cooling system is of an air type. The oil tank in the device is installed near the reducer. The starter is of high quality. Firms "Cross" motoblock CR-M8E can be found at a price of 66 thousand rubles.

Model Description CR-M10E

Trade mark "Crosser" motoblock CR-M10E is ideal for processing soft soils. Passage is at an average level. The fuel tank in the structure is installed next to the engine. The rated power of the unit is 4.5 kW.

Together with the plow, the device weighs exactly 240 kg. The system of protection against engine overheating is applied in the third class. It is also important to note that the motoblock has a good milling cutter. A convenient handle deserves special attention in the device. At maximum power, the cylinder stroke is a maximum of 78 mm. Buy motoblock presented series can be priced from 63 thousand rubles.

Customer Reviews for the CR-M12E

For the farm, the motoblocks of the presented series are great. They have a maximum power of 3.3 kW. In this case, the drive is of the belt type, and the frequency varies around 4 thousand rpm. If you believe the feedback of buyers, the transmission can last for many years. Disks in it practically do not wear out. The engine's engine capacity is 87 cubic meters. See the dimensions of this technique is difficult to call a compact, and it weighs with a plow as much as 213 kg. On the market for the presented motoblock the sellers ask about 53 thousand rubles.